Question: What Does A Solid Check Engine Light Mean?

Is it safe to drive your car with the check engine light on?

It’s okay to drive the car if the check engine light is steady.

But only if the vehicle’s essential systems such as brakes and lights are operational.

Keep a close eye on your car’s dashboard warning lights, including the coolant temperature and oil pressure..

Can a check engine light come on for no reason?

Now there’s a ton of reasons that our check engine light can come on. It can be a simple problem, like maybe the last time I put fuel in my car, I didn’t tighten the gas cap all the way. It can also be a really, really in-depth problem with sensors or wiring or really anything in between.

Can low oil cause the check engine light to come on?

Low oil pressure is a common cause of a check engine light turning on, and it can seriously interfere with your car’s performance. Usually, if this is the case, your oil light will also appear. … In any case, low enough oil pressure will disable your vehicle, so get this repaired immediately.

Is check engine light serious?

Your Check Engine Light may be indicating a simple problem that’s easy to fix—such as a loose gas cap that needs to be replaced. … A flashing Check Engine Light indicates that your vehicle’s engine is in serious trouble, whereas a steadily lit one means less urgent service is needed.

Can Autozone reset check engine light?

Yes they can make the light go out temporarily. They do it by using a scanner to erase the readiness monitors. Then until the readiness monitors reset (might be days, weeks or months) the light will stay off. That is, unless there is a hard failure then the light will come back when the car is restarted.

What does it mean when your check engine light comes on and then goes off?

It goes on when a sensor reports a voltage to the computer that is not in the prescribed range. It’s called an intermittent fault when the engine check light goes on and off. If a scanner is attached when the light is off, you should get a reading of any stored code in the computer. … It’s an emissions sensor.

How do you know if you have a bad mass air flow sensor?

Symptoms of a Faulty Mass Air Flow Sensor The engine is very hard to start or turn over. The engine stalls shortly after starting. The engine hesitates or drags while under load or idle. Hesitation and jerking during acceleration.

Does resetting your check engine light pass emissions?

If you clear the ‘Check Engine’ light, or reset the OBD-II monitors right before your emissions test, your vehicle typically will not pass because the catalyst and EVAP monitors need time to run. … You can also pre-test your vehicle, and confirm that it will pass without issue.

Why is my car shaking and engine light on?

Shaking or vibration may be caused by things such as faulty spark plugs, poor fuel pressure or misfires. Other things such as a faulty idle air control valve may cause the engine idle to drop below the normal idling RPM which may also cause the motor to shake or vibrate more than normal.

What is the most common reason for check engine light?

Replacing a faulty oxygen sensor — a sensor used to optimize a vehicle’s fuel-to-air mixture to increase gas mileage and reduce emissions — is the most common cause for a check engine light. With over 400,000 repairs nationwide, oxygen sensor replacements account for 8% of all check engine light repairs.

What does a steady engine light mean?

If the light is steady. … A blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can quickly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair.

How do I turn my check engine light off?

1- Drive The Car, and It Will Go Away By Itself: The simplest most straightforward way to get rid of the check engine light is to drive it for a little bit, and the light will turn off by itself. Once you drove your car for a couple of days (e.g., usually three days), the check engine light should be gone.

How many miles does it take to clear a check engine light?

Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results.

How long can I drive with my check engine light on?

When the check engine light is solid, you can typically drive the car for hundreds of miles without an issue. Of course, that depends on which code is stored in the vehicle’s computer. If an engine sensor is faulty, the car will usually use made up sensor values to keep running.

Where can I get my check engine light checked for free?

AutoZone is well known for doing free check engine light diagnostics. Just go into the store and ask someone behind the counter.